Installation Guide

GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
WARNING: ALL NON-TRAILER (WHEEL-LESS) LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY 18050 STABILIZING STRAPS.
WARNING:
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY **
WARNING: *** DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY ***
FOR MORE INFORMATION LOG ONTO WWW.CURTMFG.COM
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-877-287-8634
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
CURT Manufacturing LLC., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser.
If the product is found to be defective, CURT Manufacturing LLC., may repair or replace the product, at their option, when the product is returned, prepaid,
with proof of purchase. Alteration to, misuse of, or improper installation of this product voids the warranty. CURT Manufacturing LLC.'s liability is limited to
repair or replacement of products found to be defective, and specifically excludes liability for incidental or consequential loss or damage.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C.Regulation V-5 and SAE J684.
2,000 200
28
30
HYUNDAI KONA
07/02/2020
11529
60
Scan
for more
information
Parts List
DESCRIPTION
PART NUMBER
QTY
ITEM
BOLT,CAR,7/16-14 UNC,1-1/4,GRD8,YZ10-1028141
NUT,SER-FLANGE,7/16-14 UNC,GRD8,YZ20-0010342
7/16" FISHWIRE7_16 FISHWIRE
4
3
SPACER11529-SP
44
1
4
2
3
DRIVER SIDE
FRAME RAIL
DESIGNED FOR USE WITH
BALL MOUNT # 45521
EURO MOUNT
OPTION AVAILABLE
#45571 (1 7/8" BALL)
#45572 (2" BALL)
PASSENGER SIDE
FRAME RAIL
- NO DRILL
- FISHWIRE HARDWARE
- LOWER EXHAUST ON AWD MODELS
1. Move electrical harness from under the drivers side of the bumper beam to above the bumper beam. Remove
underbody panel from passenger side frame rail. Save for reinstallation in Step 4.
2. On all wheel drive vehicles only lower the exhaust by removing (2) rubber isolators.
3. Fishwire 7/16" carriage bolts and 11529-SP spacers into lower holes in the outside of the frame rails.
4. Raise hitch into position feeding fishwires through the holes in the hitch. Loosely secure with 7/16" hex flange nuts.
5. Torque 7/16" hardware to 59 lb-ft. Raise exhaust back into place and reinstall panel removed in Step 1.
TOOLS REQUIRED
SCREWDRIVER
10mm SOCKET
11/16" SOCKET
6" EXTENSION
RATCHET
TORQUE WRENCH
SAFETY GLASSES