Instruction Manual

HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-877- 87-8 32 6 4
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
CURT Manufacturing LLC., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
CURT Manufacturing LLC., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of this
product voids the warranty. CURT Manufacturing LLC.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or consequential
loss or damage.
MINI COOPER CLUBMAN
9/25/2017
11524
PAGE 2 of 2
1. Locate in wheel well and remove (1) screw on each side, and (8) screws on bottom of rear fascia using a 8mm
socket.
2. Open rear hatch doors to locate and remove (2) push pins using a pry tool.
3. Unclip plastic wheel well trim to expose and unclip electrical harness. Locate and remove (1) screw on each
side using T25 socket.
4. Carefully unclip rear fascia, starting from outside working towards the center of the vehicle. Unclip electrical
harness from bumper cover if present.
5. Remove rear bumper beam from vehicle by removing (2) nuts on each side using 18mm socket.
NOTE: If hands free split rear doors are present remove (2) fasteners and unclip from vehicle.
6. Trim heatshield using aviation shears. Use trim diagram as a reference.
NOTE: All dimensions are apporximate, confirm fit prior to trimming.
7. Raise hitch into position using studs to align, reinstall rear bumper beam over hitch and secure using existing
vehicle hardware.
8. Torque all M12 hardware to 86 ft-lbs.
9. Reinstall vehicle components removed using steps 1-6 in reverse order.
TRIM DIAGRAM