Instruction Manual

INSTALLATION WALKTHROUGH:
For more information log onto www.curtmfg.com, & for helpful towing tips log onto www.hitchinfo.com
3. Unclip plastic wheel well trim to expose and
unclip electrical harness. Locate and
remove (1) screw on each side using T-25
socket.
4. Carefully unclip rear fascia, starting from
outside working towards the center of the
vehicle. Unclip electrical harness from bumper
cover if present.
6. Trim heatshield using aviation shears. Use trim
diagram as a reference.
NOTE: All dimensions are approximate, confirm
fit prior to trimming.
5. Remove rear bumper beam from vehicle by
removing (2) nuts on each side using 18mm
socket.
NOTE: If hands free split rear doors present
remove (2) fasteners and unclip from vehicle.
5.00"
2.50"