Installation Guide

Parts List
DESCRIPTION
PART NUMBER
QTY
ITEM
HHCS,M10x1.25,35,CL10.9,YZ
10-1029841
WASHER, S-CON,7/16,YZ
30-0016342
1/4-20 x 1.00 HEX BOLT
10-1042413
1/4" WASHER
30-001881
4
NYLOCK HEX NUT
20-001481
5
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY AUXILIARY STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 877-287-8634
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
2,000 200
30
15
04-07 SCION xB
8/10/2020
11487
30
21487
2
1
FRAME RAIL
FRAME RAIL
EXISTING WELDNUTS
EXISTING WELDNUTS
-NO DRILLING REQUIRED
-REMOVE TOW HOOKS
-REMOVE FASTENER
1. Lower exhaust for easement of installation.
2. Remove tow hooks from driver and passenger side frame rails if equipped. (Return to customer.)
3. Remove plastic push fastener from driver side fascia strap and discard.
4. Raise hitch into position and secure with hex bolts and conical washers through existing weldnuts as shown.
5. Reinstall fascia strap using hex bolt, washer, and nylon lock nut.
6. Torque all 10mm fasteners to 48 lb-ft and all 1/4" fasteners to 12 lb-ft.
HITCH IS INSTALLED UNDERNEATH
PASSENGER SIDE FASCIA STRAP
(DO NOT REMOVE PLASTIC FASTENER
ON PASSENGER SIDE)
5
4
3
DRIVER SIDE FASCIA STRAP
DESIGNED FOR USE WITH
BALL MOUNT # D-21 / 45520
1 GENERIC INSTRUCTION SHEET 6/29/2007 DWS
2 CAPPED YEARS 6/4/2009 CFM
3
CURRENT STYLE 8/31/2009 CJL
4 ADDED NOTE 1. 11/9/2011 MSG
5
CHG TO GRADE 8 TORQUE SPECS
9/21/2012
AJP
6
UPDATED HARDWARE
DESCRIPTIONS/NUMBERS
8/10/2020 CJW
REVISION HISTORY
REV DESCRIPTION DATE APPROVED