Installation Guide

Parts List
DESCRIPTIONPART NUMBERQTYITEM
BOLT,CAR,7/16-14 UNC,1-1/2,GRD8,YZ10-1028241
.250 x .88 x 2.25" SPACERCM-SP2
42
NUT,SER-FLANGE,7/16-14 UNC,GRD8,YZ20-0010343
7/16" FISHWIRE7_16 FISHWIRE
44
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY 18050 STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 877-287-8634
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing LLC., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is
found to be defective, Curt Manufacturing LLC., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to,
misuse of, or improper installation of this product voids the warranty. Curt Manufacturing LLC.'s liability is limited to repair or replacement of products found to be defective,
and specifically excludes liability for incidental or consequential loss or damage.
2000 200
34
20
2013-PRESENT CHEVROLET SONIC RS HATCHBACK
10/05/2020
11398
45
1. Fishwire CM-SP2 spacers and 7/16-14 carriage bolts through access holes and into attaching holes.
Leave fishwires attached.
Note: Driver side requires reverse fishwire for rearmost fastener.
2. Raise hitch into position, being careful not to push bolts back into frame.
3. Remove fishwires. Secure with 7/16-14 flange hex nuts.
4. Torque all 7/16-14 fasteners to 70 ft.-lbs.
- NO DRILLING REQUIRED
- FISHWIRE HARDWARE
- REVERSE FISHWIRE HARDWARE
TOOLS REQUIRED
RATCHET
11/16" SOCKET
TORQUE WRENCH
4
3
1
2
PASSENGER FRAME RAIL
ACCESS HOLE
DRIVER FRAME RAIL
VEHICLE MUFFLER
ACCESS HOLE
DESIGNED FOR USE WITH
EURO BALL MOUNT
#45571 (1 7/8" BALL) &
#45572 (2" BALL)
DESIGNED FOR USE
WITH BALLMOUNT
#45521