Installation Guide
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY AUXILIARY STABILIZING STRAPS.
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT
1-877-287-8634
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
INSTALLATION STEPS
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
2,000 200
29
45
NISSAN ALTIMA COUPE SE 3.5L / S 2.5L WITH DUAL EXHAUST
10/15/2012
11357
90
24787
Parts List
DESCRIPTIONPART NUMBERQTYITEM
1/2" FISHWIRE1_2 FISHWIRE11
.250 x 1.00 x 3.00" SQUARE HOLE SPACERCM-SP6
42
CARRIAGE BOLT1/2-13 x 1 1/443
HEX FLANGE NUTHFN 121344
HOLE ENLARGEMENT DIAGRAM
(TRIM SHADED AREAS) BOTH SIDES
1
2
3
4
1) Lower exhaust (on passenger side remove 4 bolts in frame holding exhaust) for ease of installation.
2) Enlarge the existing hole between mounting holes on both frame rails.
3) Fishwire carriage bolts and spacers into position as shown.
4) Raise hitch into position and secure to vehicle using supplied flange nuts.
5) Torque all 1/2" fasteners to 110 lb-ft.
6) Raise exhaust back into postion and re-attach.
- FISHWIRING REQUIRED
- HOLE ENLARGMENT REQUIRED
- LOWER EXHAUST
- LOWER HEAT SHIELD
DESIGNED FOR USE WITH
BALLMOUNT #55001 / 45501