Installation Guide

HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-800-798-0813
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing LLC., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing LLC., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing LLC.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
MINI COOPER COUNTRYMAN
5/23/2019
11333
PAGE 3 of 5
4. Remove the first (2) plastic rivets above the 7mm bolts previously removed, by pushing
the center of the rivet through with a small punch and prying the head of the rivet out
with a flat head screw driver.
5. Lightly pull the plastic fender flare back on each side exposing an 8mm bolt and the
reflector light wiring. Unbolt the 8mm bolt with a wrench and disconnect the reflector
light and let hang.
6. Remove the (2) 10mm bolts from under the rear hatch securing the bumper fascia.