Installation Guide

Parts List
DESCRIPTIONPART NUMBERQTYITEM
.234" PLASTIC RIVET
012585341
.246 PLASTIC RIVET1162410142
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY 18050 STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-800-798-0813
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing LLC., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing LLC., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing LLC.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
2000 200
29
90
MINI COOPER COUNTRYMAN
5/23/2019
11333
180
PAGE 1 of 5
2
1
DESIGNED FOR USE WITH
BALL MOUNT #D20/45520
DESIGNED FOR USE WITH EURO MOUNT
#45562 (2" BALL) & 45561 (1 7/8" BALL)
REAR BUMPER BEAM
REAR END PANEL
-LOWER EXHAUST
-BUMPER REMOVAL
-FASCIA TRIMMING
TOOLS REQUIRED
AVIATION SHEARS, SIDE CUTTERS
MARKER
TAPE MEASURE
TOURQUE WRENCH
8mm, 10mm, 15mm SOCKETS
RATCHET
PLASTIC RIVET GUN
SMALL PUNCH
8mm BOXED END WRENCH
FLAT HEAD SCREW DRIVER
A 11624101 WAS 0125842 5/23/2019 AGC
REVISION HISTORY
REV DESCRIPTION DATE APPROVED