Installation Guide

INSTALLATION WALKTHROUGH:
For more information log onto www.curtmfg.com, & for helpful towing tips log onto www.hitchinfo.com
11. Attach hitch to vehicle so that the hitch will be
sandwiched between the frame and the bumper.
Reuse the 15mm flange nuts on the (6) frame studs
to secure the hitch and the bumper. Torque 15mm
hardware to 35 lb-ft.
12. Trim center of bumper fascia as shown approximately
2 1/4" wide by 4 1/2" long.
13. Reinstall the bumper cover by following the disassembly
steps 1-10 in reverse. Replace (6) removed plastic rivets
with those supplied in the hardware kit attach using a
plasticrivet gun.
14. Installation complete.
Trim here