Installation Guide

INSTALLATION WALKTHROUGH:
For more information log onto www.curtmfg.com, & for helpful towing tips log onto www.hitchinfo.com
3. Remove (1) plastic rivet each side of the underside of the
bumper cover by using a pair of side cutters and cutting
off the top of the rivet. Discard removed rivets.
4. Remove (2) 7mm bolts from each side of the wheel
well that secure the bumper fascia.
5. Remove the first (2) plastic rivets above the 7mm bolts
previously removed, by pushing the center of the rivet
through with a small punch and prying the head of the
rivet out with a flat head screw driver.
6. Lightly pull the plastic fender flare back on each side
exposing an 8mm bolt and the reflector light wiring.
Unbolt the 8mm bolt with a wrench and disconnect the
reflector light and let hang.