Installation Guide

Parts List
DESCRIPTION
PART NUMBER
QTY
ITEM
HHCS,7/16-14 UNC,2,GRD8,YZ10-1049711
NUT,SER-FLANGE,7/16-14 UNC,GRD8,YZ20-0010312
WASHER,FLAT,7/16,YZ30-0016633
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
HITCH WEIGHT: LBS.
INSTALL TIME: MINUTES
INSTALL NOTES:
- NO DRILLING REQUIRED
- LOWER EXHAUST
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
2000
200
25
30
8/6/2020
11318 / 24710
1) Remove tie down brackets from bottom of frame rails and rear exhaust hanger on driver side.
2) Trim rear bumper fascia as needed to provide clearance for driver side mounting plate
(approximately 1/2" x 1/2" area). Using existing fasteners mount hitch to frame rail as shown.
3) Remove metal exhaust hanger bracket from rubber isolater. Isolator will fasten directly to hitch side
plate using fasteners provided. Tubular spacer in isolator should be returned to customer.
4) Torque M12 hardware to 82 lb.-ft. and 7/16 hardware to 70 lb.-ft.
EXISTING WELD NUTS
DRIVERS SIDE
FRAME RAIL
RUBBER ISOLATOR
RE-INSTALL EXISTING
FASTENERS
2
3
1
('93-'07) SUBARU IMPREZA, ('02-'07) WRX,
('05-'07) OUTBACK SPORT & ('05-'06) SAAB 9-2X
PASSENGER SIDE
FRAME RAIL