Installation Guide

GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.

WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY 18050 STABILIZING STRAPS.

HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT
1-877-287-8634
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:


Curt Manufacturing LLC., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing LLC., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing LLC.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
2,000 200
33
75
BMW 7-SERIES
12/17/2012
11267
150
PAGE 1 of 2
BUMPER COVER
TRIM DIAGRAM
NOTE: TRIM DIMENSIONS ARE APPROXIMATE. CHECK FIT PRIOR TO COMPLETING TRIM.
TRIM
2
1
4
in
2 in
BUMPER COVER
CENTER LINE
EURO MOUNT OPTION
AVAILABLE
#45571 (1 7/8" BALL) &
#45572 (2" BALL)
DESIGNED FOR USE WITH
BALL MOUNT #55001 / 45501
EXISTING M10 x 1.5 NUTS
VEHICLE TRUNK PAN
VEHICLE BUMPER BEAM
VEHICLE BUMPER COVER
- TRIMMING REQUIRED
- REMOVE BUMPER COVER
- REMOVE BUMPER BEAM
- NO DRILLING REQUIRED
TOOLS REQUIRED
RATCHET
T-25 TORX
16mm & 8mm SOCKET
SOCKET EXTENSION
8mm END WRENCH
ROTARY TOOL
TAPE MEASURE
TORQUE WRENCH
MASKING TAPE
SAFETY GLASSES