Installation Guide

GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
* * * DO NOT EX CEED V EH I CLE M AN UFA CT U RER'S RECOM M EN DED T OWI NG C APACI T Y .* * *
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY 18050 STABILIZING STRAPS.
* * FAI LURE T O PROPERLY SUPPO RT N ON-T RAI LE R LOADS WILL V OID PRODU CT WARRANTY * *
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-877-287-8634
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERI ODI CALLY CHECK TH I S RECEI VER H I TCH T O EN SU RE T HAT ALL FAST EN ERS
ARE TI GHT AN D TH AT ALL STRUCT U RAL COM PONEN T S ARE SOU ND.
Curt Manufacturing LLC., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing LLC., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing LLC.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
2,000 200
20
10
TOYOTA COROLLA
9/11/2013
11265
20
Parts List
DESCRIPTIONPART NUMBERQTYITEM
HEX BOLTM12-1.25 x 30mm41
CONICAL TOOTHED WASHER1/242
1. If present, remove existing bolts from tow loop(s). Return tow loop(s) and bolts to owner.
2. Raise hitch into position and align the holes in the side plates with the weldnuts in the frame rails.
Secure the hitch using M12-1.25 x 30mm hex bolts and 1/2" conical toothed washers.
3. Torque all M12 hardware to 86 ft-lbs.
DRIVER SIDE
FRAME RAIL
PASSENGER SIDE
FRAME RAIL
EXISTING WELDNUTS
(BOTH SIDES)
FASCIA
DESIGNED FOR USE WITH
BALL MOUNT 45521
EURO MOUNT
OPTION AVAILABLE
45571 (1 7/8" BALL)
45572 (2" BALL)
TOW LOOP & HARDWARE
(REMOVE IF PRESENT)
- NO DRILLING
- REMOVE TOW LOOP
(IF PRESENT)
TOOLS REQUIRED
RATCHET
TORQUE WRENCH
19mm SOCKET
9" EXTENSION
SAFETY GLASSES
1
2