Owners manual

ManualsBrandsCurt ManualsAutomotiveCURT 112593 Class I 1.25 in. Receiver Hitch Fits 95-96 200SX Sentra

Parts List

DESCRIPTION

PART NUMBER

QTY

ITEM

HANDLE NUT7_16-14 TAB NUT41

HEX BOLT7/16-14 x 2.00"12

WASHER7/16 WASHER13

HEX BOLT7/16-14 x 1 1/444

CONICAL TOOTHED WASHER7/16"4

GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.

***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***

WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY AUXILIARY STABILIZING STRAPS.

** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**

HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-800-798-0813

HITCH WEIGHT: LBS.

INSTALL TIME

PROFESSIONAL: MINUTES

NOVICE (DIY): MINUTES

INSTALL NOTES:

PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS

ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.

Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,

Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of

this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or

consequential loss or damage.

2000 200

95-96 NISSAN SENTRA & 95-96 200SX

12/5/2012

11259

247270 / 257270

INSTALLATION STEPS

RUBBER HANGER

ACCESS SLOT (BOTH SIDES)

FRAME RAIL

-DRILLING REQUIRED

-LOWER EXHAUST

1. Remove the metal exhaust hanger on passenger side. Note: Rubber hanger will mount to hitch after

installation.

2. Position hitch on vehicle matching the rear most existing holes on frame rails to mounting holes on the

hitch. Using the hitch as a template, enlarge the holes for fasteners.

3. Install fasteners as shown. Note: Forward handle nut can be installed through access slot in frame rail,

rear handle nut can be placed between frame and bumper bracket.

4. Torque all hardware to 70 lb.-ft.

DESIGNED FOR USE WITH

BALLMOUNT #55001 / 45501