Installation Guide



1. Remove two M8 nuts which hold heat shield to frame rail
and bend heat shield down slightly.
2. Remove one rubber plug from each frame rail and return
to vehicle owner. Enlarge rearmost hole on passenger
side frame rail using a 1/2" drill bit.
3. Fishwire 7/16" carriage bolt with CM-SP2 spacer through
the access hole in the passenger side frame rail into the
hole enlarged in step 2. See FISHWIRE TECHNIQUE on
page 2. Leave fishwires attached to all 7/16" Note:
hardware to prevent loss of hardware inside frame rail.
4. Reverse fishwire 7/16" carriage bolt with CM-SP2 spacer
into access hole on both sides. See REVERSE PULL
FISHWIRE TECHNIQUE on page 2.

