Owners manual

ManualsBrandsCurt ManualsAutomotiveCURT 112183 Class I 1.25 in. Receiver Hitch Fits 97-01 Tiburon

Parts List

DESCRIPTIONPART NUMBERQTYITEM

HEX BOLT7/16-14 x 1 1/221

HEX BOLT7/16-14 x 1 1/442

WASHER7/16 WASHER63

HELICAL LOCK WASHER7/16 LOCK WASHER64

HEX NUT

7/16-14

2.000 x .250" BACKING PLATECM-11218-BP

GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.

***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***

WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY 18050 STABILIZING STRAPS.

** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**

HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-800-798-0813

HITCH WEIGHT:

LBS.

INSTALL TIME

PROFESSIONAL: MINUTES

NOVICE (DIY): MINUTES

INSTALL NOTES:

INSTALLATION STEPS

PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS

ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.

Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,

Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of

this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or

consequential loss or damage.

1,500 150

97-01 HYUNDAI TIBURON COUPE

12/5/2012

11218

247307

1. This hitch mounts to the spare tire well, around the tow loop. Temporarily remove contents of trunk area.

2. Position hitch on the bottom of the spare tire well, centered left to right and fully forward against the tow loop.

3. Using hitch as a drill template, drill holes for fasteners. Note: Drill only the two rear most holes

in rear angle brackets, as shown.

4. With the hitch in position, install fasteners. Install backing plate inside trunk area against the

bottom surface of spare tire well, as shown.

5. Torque all 7/16" fasteners to 70 ft-lbs.

6. Use silicone sealant to seal hardware installed through spare tire well.

7. Replace spare tire removed in Step 1.

- DRILLING REQUIRED

- REMOVE SPARE TIRE

- SILICONE SEAL TRUNK

SPARE TIRE WELL

DESIGNED FOR USE WITH

BALLMOUNT #D-55001 / 45501

DRILL REAR HOLE ONLY

(BOTH SIDES)