Installation Guide

INSTALLATION WALKTHROUGH:
For more information log onto www.curtmfg.com, & for helpful towing tips log onto www.hitchinfo.com
7. Temporarily raise hitch into position and adjust plates as
needed for hitch to slide over outsides of plates.
8. Lower hitch and torque all 1/2" hardware to 110 ft-lbs and all
M8 hardware to 23 ft-lbs.
9. Raise hitch into position and fasten to side plates with 1/2"
hardware, as shown above. Torque all 1/2" hardware to
75 ft-lbs. Reinstall (2) rubber isolators which were removed
in STEP 1.
Install is complete.
Caution: Ballmount may become hot due to center exhaust!!!