Installation Guide

INSTALLATION WALKTHROUGH:
For more information log onto www.curtmfg.com, & for helpful towing tips log onto www.hitchinfo.com
3. Fishwire (1) 1/2" carriage bolt and (1) CM-SP6 spacer into
forward most hole in each frame rail, as shown.
4. Raise driver side plate into position on driver side frame rail
and loosely fasten with 1/2" flange nut.
5. Place exhaust hanger back into position. (Plate will now be
sandwiched between frame rail and exhaust hanger.)
Reinstall (1) M8 hex nut which was removed in STEP 1.
Tighten this nut and slide plate forward or back untilNote:
holes are aligned with weldnuts.
6. Reinstall (2) M8 hex bolts which were removed in STEP 1.
Repeat STEPS 4-6 with passenger side plate.