Owners manual

Parts List
DESCRIPTIONPART NUMBERQTYITEM
HEX BOLTM10 - 1.25 x 2561
CONICAL TOOTHED WASHER3/8"
62
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY AUXILIARY STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-800-798-0813
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
2,000 200
27
10
1991-95 ACURA LEGEND
11/10/2017
11153
20
24645 / 257201
EXISTING WELDNUT
FRAME RAIL
1
2
- NO DRILLING REQUIRED
1) Remove the tie down brackets (three 10mm bolts) from each frame rail. Lower the vehicle's exhaust system
by temporarily unhooking the two rear most hangers.
2) Lift the hitch into position on the vehicle so hitch fits above exhaust tips on passenger side. This hitch will
fasten to frame rails where brackets were just removed. Install fasteners as shown. Replace exhaust hangers.
3) Torque all hardware to 48 lb.-ft.
1 GENERIC INSTRUCTION SHEET 6/20/2007 DWS
2 UPDATED TO CURRENT STANDARDS 8/25/2009 SMN
3
CHG TO GRADE 8 TORQUE SPECS
11/30/2012 AJP
4 UPDATED TOWING RATING 11/10/2017 AGC
REVISION HISTORY
REV DESCRIPTION DATE APPROVED
DESIGNED FOR USE WITH
BALLMOUNT #55001 / 45501