Owners manual

HITCH SHOWN INSTALLED
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY 18050 STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-800-798-0813
HITCH WEIGHT:
LBS.
INSTALL TIME
PROFESSIONAL:
MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
2,000 2
00
27
6
0
MINI COOPER
1
0/8/2012
11126
120
PAGE 1 of 6
Parts List
DESCRIPTIONPART NUMBERQTYITEM
CONICAL TOOTHED WASHER3/8"81
DIVIDER PANEL
NOTE: REMOVE AND
RETURN TO OWNER
HARD FOAM ENERGY ABSORBER
NOTE: REMOVE AND RETURN TO OWNER
EXISTING FASTENERS
BUMPER BEAM
DESIGNED FOR USE WITH
BALL MOUNT # D-19 / 45519
NOTE: Longer safety chains may be required to reach the
chains loops. Verify your safety chains are long enough to
clear the lower valance while turning before towing.
- REMOVE BUMPER COVER
TOOLS REQUIRED
RATCHET
TORQUE WRENCH
12" EXTENSION
12mm SOCKET
8mm SOCKET
OFFSET SCREWDRIVER
FLAT BLADE SCREWDRIVER
EXISTING WELDNUTS (BOTH SIDES)
1