Owners manual

ManualsBrandsCurt ManualsAutomotiveCURT 111203 Class I 1.25 in. Receiver Hitch Fits 09-14 Impreza

PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE ALL FASTENERS ARE TIGHT AND ALL STRUCTURAL COMPONENTS ARE SOUND

CURT Manufacturing Inc. warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective, Curt Manufacturing Inc. may repair or replace

the product at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement

of products found to be defective, and specifically excludes liability for incidental or consequential loss or damage.

For more information log onto www.curtmfg.com, & for helpful towing tips log onto www.hitchinfo.com

MAKE: STYLE:

MIN.30

WARNING: NEVER EXCEED YOUR VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY

WEIGHT CARRYING:

INSTALLATION TIPS: INSTALLATION TIME:

INSTALLATION REQUIRES:

VEHICLE PHOTO:

HITCH ILLUSTRATION:

REPRESENTATIVE PHOTO

MAKE SURE YOUR HITCH MATCHES

LEVEL OF DIFFICULTY:

MODERATE

EASY

MODERATE

HARD

THE INSTALL TIME LISTED IS FOR PROFESSIONAL

INSTALLERS. IF YOU ARE HESITANT TO UNDERTAKE

THIS TASK ON YOUR OWN, CONTACT AN AUTHORIZED

CURT INSTALLER FOR ADDITIONAL ASSISTANCE.

1. BEFORE YOU BEGIN INSTALLATION, READ ALL

INSTRUCTIONS THOROUGHLY.

2. TO EASE INSTALLATION, 2 PEOPLE MAY BE

REQUIRED.

3. USING PROPER TOOLS WILL GREATLY IMPROVE

THE QUALITY OF THE INSTALL AND REDUCE THE

TIME REQUIRED.

4. NEED HELP OR HAVE SOME QUESTIONS?

CALL TECHNICAL SUPPORT AT 800.798.0813

Safety glasses should be

worn at all times while

installing this product

YEARS:

2011-CURRENT SUBARU MODEL: IMPREZA WRX INCLUDING STI

HATCHBACK

2,000

200

TRAILER WEIGHT:

TONGUE WEIGHT:

11120 INSTALLATION INSTRUCTIONS

LBS.

10/5/2012

WARNING:

WE RECOMMEND THE USE OF 18050 STABILIZING STRAPS FOR ALL NON-TRAILER

(WHEEL-LESS) LOADS. PLEASE SEE THE CURT CATALOG OR VISIT US ONLINE AT

WWW.CURTMFG.COM FOR FURTHER INFORMATION.

PRY BAR

SCREW

DRIVER

SOCKET

10 mm

11/16"

RATCHET

MARKER

UTILITY KNIFE

TORQUE

WRENCH

TAPE

MEASURE

PART REMOVAL

FASCIA TRIMMING

REQUIRED

TEMPORARILY REMOVE

(2) FASCIA BRACKETS

LOWER EXHAUST

FISHWIRE HARDWARE

REVERSE FISHWIRE

HARDWARE

Summary of content (6 pages)

PAGE 1
1120 YEARS: 2011-CURRENT Safety glasses should be worn at all times while installing this product . INSTALLATION INSTRUCTIONS MAKE: SUBARU MODEL: IMPREZA WRX INCLUDING STI STYLE: HATCHBACK WARNING: NEVER EXCEED YOUR VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY WEIGHT CARRYING: INSTALLATION TIME: TRAILER WEIGHT: TONGUE WEIGHT: 30 MIN. THE INSTALL TIME LISTED IS FOR PROFESSIONAL INSTALLERS.
PAGE 2
INSTALLATION WALKTHROUGH: Parts List ITEM QTY PART NUMBER DESCRIPTION 1 4 7/16-14 x 1 1/2 CARRIAGE BOLT 2 4 CM-SP2 .250 x .88 x 2.
PAGE 3
INSTALLATION WALKTHROUGH: 1. Lower exhaust by removing (5) exhaust hangers. See RUBBER ISOLATOR REMOVAL DIAGRAM on page 2. (Note: Be sure to support exhaust to avoid possible damage.) 3. Trim fascia. See TRIM DIAGRAM on page 2. (Note: Check fit prior to completing trim.) 2. Remove (2) brackets which hold fascia to vehicle. These will be reinstalled in step 8. 4. Remove forward most rubber plug from each frame rail. For more information log onto www.curtmfg.com, & for helpful towing tips log onto www.
PAGE 4
INSTALLATION WALKTHROUGH: 5. Reverse fishwire 7/16" carriage bolt and CM-SP2 spacer into position in each frame rail. See REVERSE PULL FISHWIRE TECHNIQUE on page 2. 7. Thread fishwires through appropriate mounting holes on hitch and raise hitch into position. 6. Fishwire (2) 7/16" carriage bolts and (2) CM-SP2 spacers into position in bumper beam through access holes. See FISHWIRE TECHNIQUE on page 2. (Note: Leave fishwires attached to hardware to prevent loss in beam.) 8.
PAGE 5
11120 SUBARU IMPREZA WRX HATCHBACK INCLUDING STI 9/19/2014 PAGE 1 of 2 GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: 2,000 LBS. TRAILER WEIGHT & 200 LBS. TONGUE WEIGHT. ***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.*** WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY 18050 STABILIZING STRAPS.
PAGE 6
11120 SUBARU IMPREZA WRX HATCHBACK INCLUDING STI 9/19/2014 PAGE 2 of 2 HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-800-798-0813 TOOLS REQUIRED PRY BAR SCREWDRIVER 10mm & 11/16" SOCKET RATCHET MARKER UTILITY KNIFE TORQUE WRENCH TRIM DIAGRAM CENTER LINE VEHICLE REAR FASCIA 4 in TRIM 15 8 in Note: Trim dimensions are approximate. Check fit prior to completing trim.