Owners manual

ManualsBrandsCurt ManualsAutomotiveCURT 111193 Class I 1.25 in. Receiver Hitch Fits 06-10 Sky Solstice

Parts List

DESCRIPTION

PART NUMBER

QTY

ITEM

7/16 " FISHWIRE TOOLCM-438-FW11

CARRIAGE BOLT7/16-14 x 1 1/2

.250 x 1.00 x 2.50" SQUARE HOLE SPACERCM-SP1143

LARGE HEX FLANGE NUT7/16-1444

GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.

***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***

HITCH WEIGHT: LBS.

INSTALL TIME: MINUTES

INSTALL NOTES:

INSTALLATION STEPS

PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS

ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.

Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,

Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of

this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or

consequential loss or damage.

2,000

200

11119 / 247119 PONTIAC SOLSTICE AND SATURN SKY

11/19/2012

HITCH INSTALL RECOMMENDATION

RAISE PASSENGER SIDE PLATE FLANGE OVER

EXHAUST, THEN ROTATE HITCH CLOCKWISE AS

SHOWN TO INSTALL WITHOUT LOWERING EXHAUST

STEP 1

STEP 2

STEP 3

DRIVER SIDE

FRAME RAIL

PASSENGER SIDE

FRAME RAIL

1) Fishwire carriage bolts and spacers into position.

(NOTE: fishwire forwardmost holes using rearward holes, then fishwire remaining fasteners as

described above.)

2) To install hitch without lower exhaust, the passenger side must be raised first with the flange placed

over the exhaust. While raising the hitch, rotate main body clockwise into position. Passenger side

plate must be located between the carbon canister and exhaust hanger. Install supplied hex flange nuts.

3) Torque all 7/16" fasteners to 70 lb-ft.

- NO DRILLING REQUIRED

- FISHWIRING REQUIRED

WILL NOT FIT GXP OR REDLINE