Owners manual

GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
WARNING: ALL NON-TRAILER (WHEEL-LESS) LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY 18050 STABILIZING STRAPS.
WARNING: ** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY **
WARNING: *** DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY ***
FOR MORE INFORMATION LOG ONTO WWW.CURTMFG.COM
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-800-798-0813
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
CURT Manufacturing LLC., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser.
If the product is found to be defective, CURT Manufacturing LLC., may repair or replace the product, at their option, when the product is returned, prepaid,
with proof of purchase. Alteration to, misuse of, or improper installation of this product voids the warranty. CURT Manufacturing LLC.'s liability is limited to
repair or replacement of products found to be defective, and specifically excludes liability for incidental or consequential loss or damage.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C.Regulation V-5 and SAE J684.
2,000 200
35
90
INFINITI M37X, M56X, Q70
2/1/2018
11111
180
Scan
for more
information
PAGE 1 of 2
Parts List
DESCRIPTION
PART NUMBER
QTY
ITEM
HEX BOLTM8-1.25 x 35121
CONICAL TOOTHED WASHER3/8"122
TRIM DIAGRAM
TRIM
NOTE: TRIM DIMENSIONS ARE APPROXIMATE. CHECK FIT PRIOR TO
COMPLETING TRIM.
4
1
4
in
4
1
2
in
3
7
8
in
-REMOVE BUMPER
-TRIM UNDERBODY PANEL
-NO DRILLING REQUIRED
FOAM INSERT (RETURN TO VEHICLE OWNER)
DESIGNED FOR USE WITH
BALLMOUNT #D-55001 / 45501
EURO MOUNT OPTION AVAILABLE
#45571 (1 7/8" BALL) & 45572 (2" BALL)
2
1
BUMPER
BEAM
TOOLS REQUIRED
FLAT & PHILLIPS SCREW DRIVER
10mm & 12mm SOCKETS
RATCHET
TORQUE WRENCH
ROTARY TOOL
MARKER
TRUNK PAN
BUMPER BEAM SUPPORT
(BOTH SIDES)