Product Manual

PAGE 16
The TriFlex will display that it's checking calibration , that it's calibrating , or
that it needs recalibration . If the indication appears, disconnect and reconnect
the bulb from the blue wire to recalibrate. It will show when disconnected,
and / or during calibration, followed by two decimal points when complete.
Manual Control Testing
Rotate the output control thumb wheel right to its maximum setting ,
move the sensitivity adjustment toward the front of the unit to its most aggressive
setting , and slowly activate the manual control up to its full output.
While actuating the manual control the brightness of the bulb will correspond with
the output shown by the brake controller. Release the manual control to deactivate.
Accelerometer Testing
While keeping the brake control level, connect the red brake input wire of the TriFlex to
the positive terminal of the 12V battery. The brake control output will activate and the
bulb may be dimly lit.
Slowly tilt the front of the TriFlex to about 45° and the brightness of the bulb will
increase corresponding with the output shown by the brake controller. Slowly tilt
the front of the TriFlex back to level and the brightness of the bulb will decrease
corresponding with the output shown by the brake controller.
When finished testing disconnect the wiring from the positive terminal of the 12V
battery ensuring the exposed contacts to not make contact. If the TriFlex does not
function as described during the above test steps return the brake controller for
service or replacement.