Product Manual

PAGE 13

SETUP

Once all electrical connections are complete and the single decimal point is seen,

while parked on a level surface, plug the trailer's electrical connector into the tow

vehicle's plug.

Making the trailer connection initiates the mounting position calibration mode.

may be seen on the display followed by either or . If appears,

recalibration is needed. To recalibrate, unplug and replug the trailer's electrical

connector. While calibrating, the display will show or may ﬂash the Output

setting. When appears, the unit is calibrated and ready for setup.

Make the following preliminary adjustments with the trailer connected and engine

running to ensure proper charge voltage. The vehicle must be in park or neutral

with the parking brake applied, foot off the brake pedal, and no manual control

actuation:

Adjust output to by turning the output control wheel left or right as needed.

Adjust sensitivity to by moving the sensitivity control forward or back.

Test Drive and Adjustment

Both output and sensitivity can be adjusted to achieve smooth ﬁrm stops.

Output and sensitivity adjustments should only be made while stopped, with the

transmission in park or neutral, parking brake applied, foot off the brake pedal,

and no manual control actuation. Output and sensitivity settings will ﬂash while

adjustments are made and for a few seconds after.