Product Manual

MAINTENANCE

REQUIREMENTS

REMOVAL &

REINSTALLATION

For your convenience, the A25 5th wheel hitch may be

disassembled to ease removal. This section will discuss

the two different ways the 5th wheel can be removed.

Your CURT A25 5th wheel hitch has been designed to

offer years of safe and reliable service. To achieve the best

performance and the longest possible service life, please

follow the maintenance schedule on the next page.

REMOVAL - OPTION 2

REINSTALLATION

We recommended that the head be separated from

the mid-section and sides be removed as one unit.

NOTE: If binding occurs, loosen the four 14mm

leg mounting bolts to free them from the rails.

1. Remove center lynch pin and large pivot pin

2. Lift and remove head assembly and yoke

3. Remove the rail clips and mounting pins

4. Lift and remove mid-section and leg assembly

Reinstall the 5th wheel in the reverse order it was removed. If

removal method was per Option 2, please follow the steps below:

1. Place the mid-section, still attached

loosely to the legs, into the mounting rails

2. Insert the four mounting rail pins & clips

3. Re-torque the four pilot hex bolts to 100 foot lbs.

Figure 24

REMOVAL - OPTION 1

To remove the entire 5th wheel hitch from the base rails.

Follow the two steps below and refer to Figure 23 for assistance.

1. Remove the four clips and mounting rail pins

2. Remove the 5th wheel unit from the mounting rails

Figure 23

CURTMFG.COM • NEED ASSISTANCE? • 1.800.798.0813 • 16180-INS-RA • PAGE 8