Installation Manual

Parts List
DESCRIPTIONPART NUMBERQTYITEM
HEX BOLT1_2 - 13 x 4 1_2 HEX
4
1
FW, 12, ZPFW1242
HEX FLANGE NUT
HFN 121343
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT DISTRIBUTION HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
HITCH WEIGHT: LBS.
INSTALL TIME:
MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
3500
350
15
20
4000
400
13432 JEEP WRANGLER 2-DOOR & 4-DOOR
3/18/2008
1) Remove three bolts that are securing the existing tow hook to the bumper beam. Detach the muffler
from the rubber muffler hanger and lower the exhaust for ease of installation.
2) Position the hitch over the bumper beam and align the holes of the hitch with holes in the cross member.
When the hitch is properly positioned, the hitch will be centered in the existing rectangular cutout at the
bottom of the bumper fascia.
3) Insert fasteners as shown making sure the flange nuts are installed on the exterior side of the hitch.
4) Torque all 1/2" fasteners to 75 lb-ft.
1
2
3
BUMPER BEAM
EXISTING HOLES
IN BUMPER BEAM
-NO DRILLING REQUIRED
-LOWER EXHAUST