Product Manual

INSTALLATION WALKTHROUGH:
For more information log onto www.curtmfg.com, & for helpful towing tips log onto www.hitchinfo.com
3. Fishwire 1/2" carriage bolts and (2) SP6 spacers through the
access holes and out the existing holes in the bumper beam.
4. With the hitch side plates flat on the ground, align the center holes of
the hitch with the bolts fishwired in the bumper beam and loosely secure
with 1/2" flange nuts. Raise the hitch and bumper beam into position by
aligning the hitch and bumper beam holes with the holes in the end of
the frame. Secure with the M10-1.25 x 30mm hex flange bolts provided
and the M10 nuts removed in Step (2).
5. Torque all 1/2" hardware to 110 ft-lbs and all M10 hardware
to 48 ft-lbs.
6. Reinstall bumper cover with fasteners removed in Step (1).
Starting with the outside bottom fasteners and working in.
Note
: If present, reconnect the back-up sensor. You may
need to gently flex the bumper cover to align with fastener holes.