Product Manual

ManualsBrandsCurt Manufacturing ManualsHitch Receivers + AdaptersCurt Custom Fit Class III Receiver Hitch - Fits 2014-2019 Toyota Highlander

INSTALLED HITCH

UNDERBODY PANEL TRIM DIAGRAM

HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-800-798-0813

INSTALLATION STEPS

PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS

ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.

CURT Manufacturing LLC., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be

defective. CURT Manufacturing LLC., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper

installation of this product voids the warranty. CURT Manufacturing LLC.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for

incidental or consequential loss or damage.

TOYOTA HIGHLANDER

13200

PAGE 2 of 2

1. Remove the (7) fasteners securing the driver side underbody panel.

After lowering the underbody panel return it to the owner or trim and reinstall in Step (6).

2. Remove the (4) rubber plugs from the frame rails and unscrew the (3) threaded plastic inserts from the

driver side frame rail. Return plugs and inserts to owner.

3. Mark the lower fascia exhaust air deflector 2" from the "hinge" and trim as shown above to allow room for the hitch.

4. Remove the (3) M12 bolts securing the metal fascia tab and tow loop to the passenger side frame rail.

Remove the (1) fascia screw and metal fascia tab from the passenger side underbody panel.

Return the fascia tab, tow loop, and fasteners to owner.

5. Raise the hitch over the exhaust and align the holes in the hitch with the weldnuts in the frame.

Secure the hitch to the frame using the supplied M12-1.25 hex bolts and 1/2" conical toothed washers.

6. Torque all 12mm hardware to 86 ft-lbs.

7. Mark and trim underbody panel. Reattach underbody panel using fasteners removed in Step (1).

Note

: See underbody panel trim diagram. Dimensions are approximate, confirm fit prior to trimming.

Use ribs of the underbody panel as cutting guides.

DRIVER SIDE

FRAME RAIL

FASCIA

HITCH

MUFFLER

PASSENGER SIDE

FRAME RAIL

4.00 in

3.00 in

NOTE: USE RIBS OF THE

UNDERBODY PANEL AS

CUTTING GUIDES

NOTE: DIMENSIONS ARE

APPROXIMATE, CONFIRM

FIT PRIOR TO TRIMMING

LOWER FASCIA TRIM DIAGRAM