Operation Manual

22
Operation
Starting a Wash Cycle
1. Ensure the unit is connected to the mains power and the water supply is fully opened (water pressure
between 0.04MPa and 1.00MPa).
2. Open the door. Pull out the dishwasher basket, load the dishes and push the basket back.
3. Pour in the detergent or place the detergent tablet in the detergent compartment and close firmly
afterwards.
4. Close the dishwasher door. A click sound should be heard when the door is closed correctly. Do not
slam the door.
5. Press the On/Off button.
6. Select the wash cycle programme based on the loading and soil requirements. Please refer to the
section Wash Cycle Table.
7. The programme indicator will light up for the selected programme.
8. Press the Start/Pause button, the washing cycle will begin shortly and the programme indicator will
flash.
Changing a Programme
To change the programme if the washing cycle has already started, follow the steps below.
1. Open the door slightly to avoid water spillage before opening the door fully. Check if the unit has
dispensed the detergent or detergent tablet. This will depend on how long the washing cycle was
running for.
2. If the detergent dispenser lid is opened, we suggest you to allow the wash cycle to complete.
3. If the detergent dispenser lid is still closed, press the On/Off button to pause the washing. You can
then close the dishwasher door and press the On/Off button again. Then, press the required new
programme button and confirm the selection by pressing the Start/Pause button. The unit will start
the new washing cycle shortly.
At the End of a Programme
At the end of a programme, the dishwasher will beep.
Switching O the Unit
To save energy, remember to switch the dishwasher off using the ON/OFF button. The dishwasher will
continue to use electricity until it is switched off with the ON/OFF button.
If you open the dishwasher’s door during the washing cycle and then close it, the dishwasher will continue the
current washing programme after 10 seconds. However, if the door is not closed correctly after 1 minute, the
dishwasher will beep at 1 minute intervals.
If the dishwasher is not going to be used for a long period of time, e.g. whilst on holiday, disconnect the unit
from the mains supply.
Unloading the Dishwasher
Allowing dishes to cool down before unloading is important as dishes tend to break and chip more easily
when they are hot. Therefore, if you open the dishwasher door fully after switching off, it will allow the
dishes to cool down much faster.