Instruction manual

GB-24
Helpful Tips and Guide
• Repairs should only be carried out by a qualified technician in strict accordance with current
local and national safety regulations. Unauthorised or incorrect repairs could cause personal
injury or damage to the unit.
• Before calling for service, please refer to Helpful Tips and Guide to solve some general problems
by yourself.
Fault Code
Codes Possible Causes Remedy
Light is flashing.
Water tap is not turned on. Turn on the water tap.
Low water pressure (<0.04MPa) Turn on the water tap and
ensure it is in full position.
Flow meter is broken.
The wire terminals which connect
the flow meter are loose.
Disconnect from the mains.
Disconnect the water inlet.
Call a qualified technician.
Light is flashing.
The tank is leaking.
The hose is leaking.
The float switch is broken or PCB
is faulty.
Technical Problems
Technical Problems
Problem Possible Causes Remedy
The dishwasher does not start.
The door is not properly closed. Close the door firmly.
The unit is not connected to the
mains.
Insert the plug to the mains.
The unit is not switched on. Press the On/Off button and select
a programme.
The drain pump is not working
properly.
The anti-flooding system has
operated.
Disconnect from the mains.
Disconnect the water inlet.
Call a qualified technician.
General Problems
Problem Possible Causes Remedy
Detergent residue is left at the
end of the programme.
The detergent slot was still
damp when detergent was
added.
Make sure the slot is dry before
adding detergent.
The detergent dispenser lid
cannot be closed properly.
Clogged detergent residue is
blocking the catch.
Clean the catch.
Knocking noise in the wash
cabinet.
A spray arms is knocking against
an item in a basket.
Interrupt the programme, and
rearrange the items which are
obstructing the spray arm. See the
section “Loading the dishwasher”.
Smearing appears on glassware
and cutlery.
The rinse aid dosage is set too
high.
Adjust the dial of the rinse aid
dispenser to a lower setting.
CDW60W10_IB_110324.indd 24 24/03/2011 10:27 AM