Specifications

This section is to be used by only a Safe Gas Regisered Engineer (in the UK). Contact a Safe Gas Regisered

Engineer to change the Hob Injectors. It is illegal to attempt to change the Hob Injectors yourself.

Replacement of Burner Injectors

The gas ow adjustment is made by turning a small screw on the control valves.

From LPG to Natural Gas From Natural Gas to LPG

Large Burner 1 turn anti-clockwise Turn clockwise

Standard Burner 3/8 turn anti-clockwise Turn clockwise

Small Burner 1/4 turn anti-clockwise Turn clockwise

Adjusting the Reduced Flame Position

For easier adjustment of the reduced ame position, you can remove the

control panel and the microswitch (if applicable) during adjustment.

The ame length in the minimum position is adjusted with a at screw

located on the side of the valve spindle under the hob controls. The screw

must be loosened turn (anti-clockwise) when changing from LPG to NG.

In changing from NG to LPG, the same screw must be fully tightened

(clockwise). Make sure that the appliance is disconnected from the mains

supply and the gas feed is on.

To determine the minimum position, ignite the burners and leave them

on in minimum position. With the help of a small screwdriver tighten

(clockwise) or loosen (anti-clockwise) the adjustment screw around 90

angular degrees. When the ame has a length of at least 4 mm, the gas is

well distributed. Make sure that the ame does not die out when passing

from the maximum position to the minimum position. Create an articial

wind by fanning your hand at the ames to see if they are stable.

Injector

Spanner

Adjustment

Screw

Valve with Flame Failure

Device

Select the injectors to be replaced according to the “Table for the choice of the injectors”.

To Replace the Hob Injectors

• Turn o and isolate the Gas and Electric supplies to the cooker.

• Remove the burner ring and cap.

• Unscrew the injectors. For this, use a 7 mm socket spanner (not included).

• Replace the injector with the ones from the conversion set, with the corresponding diameters suitable to the

type of gas that is going to be used, according to the information chart (which is also supplied in the conversion

set).

* All images are for indication only; please refer to your individual unit for actual item.

CFSGWH_SV12_IB_120607_Annie.indd 26 12年6月7日下午7:15