Owner`s manual

GRIP SHIFTERS

Grip Shift™ - Installation

Slide front Grip Shift™ assembly over left side of handlebar leaving proper clearance for handlebar grip. If necessary, 1.

move the brake lever to accommodate Grip Shift™ and handlebar grip.

Rotate assembly until cable exits beneath brake lever with adequate clearance for brake lever movement.2.

Firmly tighten recessed clamp screw. Installation torque should be 20 in.-lbs.3.

Slide the two 7/8” plastic washers over handlebar. The washers prevent the grip from interfering with Grip Shift™ 4.

rotation.

Slide handlebar grip over handlebar. Thread the cable inner wire through cable housings and frame, and attach to 5.

derailleur. Make sure that the cable is in the V groove at the derailleur attachment bolt. If trimming the cable housing is

necessary, be sure to replace the housing end cap.

Adjust indexing.6.

Slide rear Grip Shift™ over right side of handlebar and repeat steps 2 - 6. 7.

Actuate front and rear brake levers to be certain of proper operation. If Grip Shift™ interferes with brake lever 8.

movement, rotate brake lever or Grip Shift™. Check for proper brake lever operation again.

Grip 7/8” Plastic Washers

Barrel Adjuster Cable