Owner`s manual

90
Hub Bearing Adjustment
When checked, the hub bearings of either wheel will require
adjustment if there is any more than slight side play.
Check to make sure neither locknut is loose.1.
To adjust, remove wheel from bicycle and loosen the locknut on 2.
one side of the hub while holding the bearing cone on the same
side with a flat open end wrench.
Rotate the adjusting cone as needed to eliminate free play.3.
Re-tighten the locknut while holding the adjusting cone in 4.
position.
Re-check that the wheel can turn freely without excessive side 5.
play.
How To Fix a Flat Tire
If you need to repair a tire, follow these steps:
Remove the wheel from the bicycle.1.
Deflate the tire completely via the valve. Loosen the tire bead 2.
by pushing it inward all the way around.
Press one side of the tire bead up over the edge of the rim. 3.
Note: Use plastic tire levers, not a screwdriver, otherwise you
may damage the rim and tire.
Remove the tube, leaving the tire on the rim.4.
Locate the leaks and patch using a tube repair kit, carefully 5.
following the instructions, or replace the tube. Note: Ensure that
the replacement tube size matches the size stated on the tire
sidewall and that the valve is the correct type for your bicycle.
Match the position of the leak in the tube with the tire to locate 6.
the possible cause and mark the location on the tire.
Lock
Washer
Axle
Lock Nut
Hub Body
Ball Bearings
Bearing
Cone
Washer
Axle Nut
Push tire bead
into the center
of the rim.