Owner`s manual

Side Pull Brake

Loosen the cable anchor nut and thread the brake cable through it.

Tighten the nut by hand until it holds the cable in place. Squeeze the

brake arms together against the rim of the wheel. Loosen the nuts on the

brake shoes and turn until they match the angle of the rim. Tighten the

nuts securely. Pull down on the end of the brake cable with pliers, hold

taut and securely tighten the cable anchor nut.

Spin the wheel, the brake shoes should not contact the rim at any point

and should be an equal distance from the rim on both sides. Make sure

all nuts and bolts are securely tightened. Test the brake levers 20-25

times to take care of any initial cable stretch. Be sure to

tightly secure the brake fixing nut behind the fork.

Side Pull

Brakes

Cable

Adjusting

Barrel

Center Bolt

Cable

Anchor

Nut

Brake Shoe

Fixing Nut

in Back

Brake

Arm

When assembling or adjusting the brakes, make

sure the cable anchor is tight. Failure to securely

tighten the nut could result in brake failure and

personal injury.