Owner`s manual

70
Rear Fender
The rear fender is mounted at the seatstay brace. There are two
ways in which to mount your rear fender. The first is the screw
mounting system (see figure 3), and the second is the 10mm bolt
and screw system (see figure 4). Identify the mounting system used
on your bicycle and follow the given instructions for that particular
type of mounting system.
1. Screw Mounting System
First remove the rear wheel. Place the fender assembly between
the stays, making sure the fender bracket holes line up with those
in the frame. Attach the fender by using two screws to directly
mount the fender onto the frame. The mounts are located below
the seat post and near the rear of the crank. Tighten all screws
until snug.
2. 10mm Bolt and Screw System
First remove the rear wheel. Place the fender assembly between
the stays, making sure the fender bracket holes line up with those
in the frame. Attach the fender by using one screw to directly
mount the fender onto the frame near the crank. Next, use the
10mm hex bolt and nut to attach the fender to the brace between
the seat stays, near the seat post. Tighten all bolts and screws
until snug.
figure 3
figure 4