Owner`s manual

67
Rear Pivots
The pivot assembly is a simple mechanism that allows the
rear swingarm to move up and down in combination with
a rear suspension. Size, shape, and compounds will vary
between models; however, operating principles are the
same. A shaft will pivot inside of two bushings secured in
place with bolts. Pivots should be kept clean and free from
dirt and should be disassembled and re-greased at least
once every riding season. Please note the drive side crank
arm must be removed from the spindle before attempting to
work on the pivot. Some models have two, small (2.5mm)
Allen bolts on the underside of the bottom bracket shell.
These must be removed before attempting to disassemble the
pivot. After disassembling and cleaning, the shaft of the pivot
assembly should be lightly coated with lithium-based grease,
as well as the bushings and the threads of the attaching
hardware. Please remember: Never use WD-40™ to grease
components. It is a degreaser that will not provide required
lubrication and has a tendency to attract dust.
1
1
2
2
3
3
Attaching Bolt1.
Bushing2.
Shaft3.
Pivot Assembly1.
Bottom Bracket Cup & Lockring2.
Swingarm3.
1
2
3