Owner`s manual

The wheel is tightly secured when the serrated surfaces of the 5.

quick release clamping parts actually begin to cut into the bicycle

frame/fork surfaces.

Note that the same procedure applies when operating a quick 6.

release seat post binder mechanism.

If you can fully close the quick release without wrapping

your fingers around the fork blade for leverage, and the

lever does not leave a clear imprint in the palm of you

hand, the tension is insufficient. Open the lever, tighten the

adjusting nut, and try again. Continue until the QR lever

closes properly. Secondary retention devices are not a

substitute for a correct quick release adjustment. Failure to

properly adjust the quick release mechanism can cause the

wheel to wobble or disengage, which could cause you to

lose control and fall, resulting in serous injury or death.

Tighten both rear wheel axle nuts or the quick release

mechanism securely. Failure to do this may cause the rear

wheel to dislodge from the frame dropouts resulting in

serious damage or injury.

Rear Wheel

QUICK RELEASE LEVERS

It is important to check the quick release levers before every ride to ensure

all connections are made properly and securely.

Periodically, disassemble the mechanism from the

bicycle and inspect for any wear or damage and replace if

necessary. When reinstalling, it is very important to ensure

the connections are made properly.