Owner`s manual
Currie Technologies Technical and Customer Service 1-800-377-4532
Q
S
R
Installation:
Your electric bicycle comes with a 24 volt sealed lead-acid (SLA) battery. To install the battery, simply slide it into the rear
rack
(as shown in gure Q, Currie logo facing outward) making sure you rst remove the rubber terminal cover if present.
This type of battery does not have a memory, and riding on a partial charge will not harm the battery in any way. Recharge
time for this battery is 6-8 hours to reach a full charge.
Locking:
Locks are included with the RMB rack to hold the batteries in place when riding. It is recommended that the battery pack be
locked whenever you are riding in order to maintain a strong connection. After sliding a battery pack into place, lock it
with one of the included keys
(usually in the parts box or rubber-banded to the rack), making sure the lock cylinder fully
engages into the battery case. All keys included with your bicycle are identical.
Operation
To turn your bicycle on:
Ezip RMB Bicycles & Izip RMB bicycles prior to 2010: Flip the three-position
battery selector switch, located on the rack behind the rear reector, to the side
corresponding to the attached battery you wish to use.
This turns the bicycle on, indicated
by the glowing lights on the throttle. To turn the bike off, ip the battery selector switch to the
neutral center position.
Izip RMB Bicycles: Flip the two-position battery selector switch, located on the rack
behind the rear reector, to the side corresponding to the attached battery you wish to
use.
Once you have selected your battery, press the “ON/OFF” switch next to the throttle on
the handlebars (as shown in photo S1) to turn the bike on. To turn the bike off, simply press “ON/
OFF” again; there is no need to change the position of the battery selector switch.
PAS/TAG System:
Using the “PAS/TAG” selector button on the throttle, you can switch between PAS
(Pedal Assist) and TAG (Twist And Go) modes. TAG mode uses a straight throttle
system; motor power is directly controlled by the throttle on your handlebars. When
the bike is switched to PAS mode, a sensor in the drivetrain is activated, allowing
the motor to automatically run at up to 50% power when it senses pedaling. This
PAS mode helps to maximize range as it only activates the motor when the rider is
pedaling.
For Izip RMB
Bicycles Only
ON/OFF
Button
For Ezip RMB
Bicycles Only
Izip: ON/ON
(Battery selector)
Ezip: ON/OFF/ON
(Power and selection)
1
2
PAS/TAG
SELECTOR
PAS/TAG
SELECTOR
Battery