Owner`s manual

Front Wheel
12. Determine whether your front wheel uses a solid or quick release axle
(see photo J/K).
Solid axle with safety
washer and nut
Quick release
J
L
K
12a. Solid Axle: Loosen the axle nuts on each side of the wheel. Insert the wheel
into the fork, making sure the safety washer on each side is to the outside of the fork, as
shown in photo L.
Orient the safety washers as shown so their hooks insert into the holes in the fork, then
tighten the axle nuts rmly with a 15mm open end wrench (included in your parts box).
12b. Quick Release: Remove the end nut and one spring from the quick release
skewer, taking care not to lose either of the small springs. Push the skewer through the
front hub, then replace the spring and end nut. Leave the nut loose for now, about two
turns in.
Solid Axle
Safety washer hooks into dropout
End Nut
SpringSpring
Skewer
For solid axles, • proceed to step 12a.
For quick release axles, • proceed to step 12b.
M
N
Currie Technologies Technical and Customer Service 1-800-377-4532
Insert the wheel into the fork, as shown in photo N.
Securely close the quick release. Refer to the appendix of this document for more information
on the use and adjustment of quick release levers. It is vital to your safety that you understand
and properly secure this lever!