Owner`s manual

8
Customer Service 1-800-377-4532
Currie Technologies
®
Section 3 - BASIC ASSEMBLY & SET-UP
IMPORTANT: Some adult assembly required. Before using your scooter
please be sure to read and follow the basic assembly, set-up and operating
instructions. Following these instructions will help insure safe riding.
TOOLS REQUIRED:
Listed below are the tools you may need to assemble and adjust your Elec-
tro-Drive™ scooter depending on model:
STEPS FOR BASIC ASSEMBLY
Remove scooter from carton. Remove all of the packaging materials
from the scooter.
Install the front wheel (certain models will have the front wheel
already installed) being sure to properly install the safety washers.
Align the front wheel in the fork and tighten the axle nuts. Wait until
after you have installed the handlebars to connect the front brake (if
your scooter is so equipped).
Install the handlebars onto the stem, align and tighten.
Unfold the stem hinge. Be sure the locking pin is fully engaged and
close the quick release lever.
The brake(s) come pre-assembled from the factory (some scooters
have one brake while others have two brakes). However, you need
to check to make sure it is connected and operating properly. Test
the brake lever(s) by squeezing it. It should stop the wheel(s) easily
and NOT come in contact with the handlebar. If the brake lever(s)
needs adjusting, refer to pages 19-20 for instructions. If the brake(s)
does not work properly, DO NOT RIDE THE SCOOTER. Call Cus-
tomer Service at 1-800-377-4532 for further assistance.
Install the seat assembly, if so desired, by fully sliding the seat
tube into the frame and securing the pinch bolt. If the seat tube is
equipped with an indexing pin be sure to align this properly with the
frame.
Install the seat onto the seat tube if not already done and align
saddle angle and tilt and tighten accordingly.
Remove the battery charger from its box. Make sure the power
switch on the scooter is in the “OFF” position. Connect the charger
1.
2.
3.
4.
5.
6.
7.
8.
10mm box wrench
13mm box wrench
15mm box wrench
17mm cone wrench
•
•
•
•
4mm hex key wrench
5mm hex key wrench
6mm hex key wrench
Phillips screwdriver
Bicycle tire pump
•
•
•
•
•
Chain Drive Scooters.indd 8Chain Drive Scooters.indd 8 3/18/2008 12:18:14 PM3/18/2008 12:18:14 PM