Owner`s manual

38
Customer Service 1-800-377-4532
Currie Technologies
®
Section 7 - PRE-RIDE CHECKLIST
It is recommended that you perform each of these checks before each and every ride.
TIRES
Check tires for any cuts or unusual wear.
Check tire pressure and inflate to recommended pressure as necessary.
HANDLEBARS and FRAME
Inspect for bent, damaged or cracked welds and tubing caused by aggressive
riding.
Ensure the handlebars are properly aligned and secured tight enough so that you
cannot twist them out of alignment.
NUTS and BOLTS
Inspect and tighten all fasteners before each and every ride.
If unsure on how to inspect and tighten fasteners, seek advice from an authorized
and experienced mechanic.
BRAKES
Ensure brake control cable(s) are lubricated, correctly adjusted and display no
obvious wear.
Ensure brake control lever(s) are not binding and the clamps are tightly secured to
the handlebar.
Squeeze the brake lever(s) to make sure that it does not bottom out on the handle-
bar and the brake(s) holds the scooter from being pushed forward.
Squeeze the brake lever(s) to ensure the brake inhibitor(s) stop the motor.
Ensure brake shoe pads are not worn out and are correctly positioned.
ELECTRICAL SYSTEM
Be sure the batteries are fully charged by using the battery gauge (colored LED’s)
on the throttle.
Ensure your battery pack is properly installed in your scooter with the deck plate
attached and secured.
Ensure the accelerator are secure, in good condition and working properly.
RIDING GEAR
Always wear an approved helmet.
Always wear proper protective equipment such as; eye protection (goggles or face
shield), gloves, boots, long sleeved shirt or jacket and long pants.
Never operate this product barefoot or in sandals as this increases the risk of
injury.
Always obey all local traffic laws
□
□
□
□
□
□
□
□
□
□
□
□
□
□
□
□
□
□
Chain Drive Scooters.indd 38Chain Drive Scooters.indd 38 3/18/2008 12:18:53 PM3/18/2008 12:18:53 PM