Service manual

19
Currie Technologies // Service Manual (Version 2008a)
Use only Currie Authorized SLA chargers with bicycles
equipped with SLA batteries. Using any other charger
will damage the batteries and void your warranty.
!
HOW TO USE THE SLA CHARGERS (STANDARD)
Plug the charger into the outlet. The indicator light on
the top of the charger will illuminate when the charger
is working properly. Refer to the sticker on the charger
for actual status light indication.
Insert the plug (XLR, 2v1h or 3v) into the charger port
on the bike being sure the charger plug is fully seated
in the charger port. The light should be solid red or
blinking green to indicate charging however you will
need to refer to the sticker on the charger for actual
status light indication.
Once the battery reaches full charge, the light will
return to solid green however you will need to refer
to the sticker on the charger for actual status light
indication.
When charging is complete, unplug the charger from
the wall before removing it from the charger port.
Charge for the full time. If the battery still has not charged, you
may need to replace it.
1.
2.
3.
4.
Example of SLA Charger
w/ XLR Plug
XLR Plug
2v1h Plug
3v Plug
SLA Charger could come with the below plugs
depending on your model of hybrid electric bicycle
Electric Bikes with Seat Tube Mounted Battery (STB) Packs
- Remove the power cable from the charger port and attach
charger.
Electric Bikes with Rack Mounted Battery (RMB) Packs -
Lift the battery pack handle to expose the charger port and
attach charger.