Service manual

17
Currie Technologies // Service Manual (Version 2008a)
CHARGER
The hybrid electric bicycle comes with its own "Smart Charger” that connects with an easy-access charger port for
recharging the batteries. This charger unit has lights that show the battery charge status. Refer to the instructions that
appear on the charger unit and its instructions.
Batteries work best when they have a full charge, so always be sure to recharge them fully after each ride. If you leave
them in a run-down condition, without recharging them, it will shorten their life expectancy.
Li-Ion (Lithium Ion) batteries - charge for 4-6 hours for full charge
NiMH (Nickel Metal Hydride) batteries - charge for 4-6 hours for full charge
SLA (Sealed Lead Acid) batteries - charge for 6-8 hours for full charge
The charger may get warm to the touch, so make sure you charge them in an open area and do not lay anything on
the charger unit while charging. Although you cannot over-charge the batteries using the Currie “Smart Charger”, we
recommend that you do not leave the charger plugged in for more than 24 hours.
If your charger shows a solid green light after charging for a short period of time, your battery may have been only
partially discharged (short ride), or this may be the sign of a partially worn out battery with reduced storage capacity.
Continue charging for the full time, to cover all the bases. If the battery still has not charged, you may need to replace
it.
Even with proper care, a rechargeable battery does not last forever. Average battery life depends on use and
conditions.
The charger and charger port should be regularly inspected for damage (cord, plug, enclosure, etc.).
If damage is found stop using until the damaged part can be repaired or replaced.
!