Owner`s manual
14 15
www.CurrieTech.com
Currie Technologies
®
Currie Technologies
®
OM Direct Drive Scooters - 2012.indd
Modied 05/25/2012
QR LEVER ADJUSTMENT:
If the quick release lever is either
too tight (cannot be flipped to its fully
locked position) or is too loose (can
be too easily flipped to its locked
position) you will need to adjust the
QR (Quick Release) Lever.
Open the QR lever (Ref Photo A) and
adjust the 10mm nut underneath the
center pin (Ref Photo B).
If the QR lever was too tight initially
you will need to loosen the nut a 1/4
turn at a time. Test the adjustment
you have made by closing the QR
lever (Ref Photo C). The lever should
be tight in its closed position and un-
able to vibrate loose.
If the QR lever was too loose initially
you will need to tighten the nut a 1/4
turn at a time. Test the adjustment
you have made by closing the QR
lever (Ref Photo C). The lever should
be tight in its closed position and un-
able to vibrate loose.
Repeat adjustment as necessary
until QR lever is properly tightened.
If you are unable
to properly adjust the QR lever DO
NOT RIDE THE SCOOTER. Contact
Currie Technologies
®
Customer
Service at 1-800-377-4532 for further
instructions. Failure to do so may
result in serious injury or death to the
rider or severe damage to the scooter.
Photo A
Photo C
Photo B
WARNING
!
BATTERY PACK, CHARGER PORT AND CHARGER
ELECTRO-DRIVE™ SMART CHARGER: The Electro-Drive™ scooter comes
with its own Electro-Drive™ Smart Charger that connects with an easy-
access charger port for recharging the batteries. This charger unit has lights
that show the battery charge status. Refer to the instructions that appear on
the charger unit and its instructions.
Use only a Currie Authorized Smart Charger to charge
the batteries. Using any other charger may damage the
batteries and void your warranty.
HOW TO CHARGE THE BATTERIES
1. IMPORTANT: Be sure the
power switch on the scooter
is in the “OFF” position. (Ref
Photo A)
2. Rotate open the charger port
cover (Ref Photo B).
3. Insert the Battery Charger’s
XLR (Male) plug into the Char-
ger Port (Ref Photo C).
4. Plug the Battery Charger’s AC
plug into a standard, grounded
110V AC outlet.
5. Let the batteries charge until
the charger lights indicate that
the batteries are fully charged,
then unplug the charger from
the scooter and the AC outlet.
Batteries like to have a full charge, so
always be sure to recharge them fully
after each ride. If you leave them in
a run-down condition, without quickly
recharging them, it will shorten their
life expectancy. The charger may get
warm to the touch, so make sure you
charge them in an open area and
do not lay anything on the charger
unit while charging. Although you
cannot over-charge the batteries
Photo A
WARNING
!
Photo C
Photo B