Owner`s manual
12 13
www.CurrieTech.com
Currie Technologies
®
Currie Technologies
®
OM Direct Drive Scooters - 2012.indd
Modied 05/25/2012
6. Rotate the stem QR lever
forward into of the upper
plate (Ref Photo A). Close
the stem QR lever (Ref
Photo B) being sure the QR
retention pin (silver) is fully
engaged with the upper
plate.
7. Install the handlebars onto
the stem, align and tighten.
Photo B
Photo A
8. Align the handlebars to the
front wheel. The handlebars
must be perpendicular to the
front wheel.
9. Repeat steps 2 and 3 to once
again access the steerer bolt
(6mm Allen Bolt or 13mm
Hex Bolt). Fully tighten the
steerer bolt. The stem is held
in position with the expander
bolt and wedge.
10. Repeat steps 5 and 6 to once
again secure the folding
stem. Be sure the QR
retention pin (silver) is fully
engaged with the upper
plate.
If you are unable to lock the
WARNING
!
handlebar folding hinge properly, or its Quick- Release
lever, or properly secure the two main handlebar parts
to the scooter, DO NOT RIDE THE SCOOTER. Contact
Currie Technologies
®
Customer Service at 1-800-377-
4532 for further instructions. Failure to do so may result
in serious injury or death to the rider or severe damage
to the scooter.