Owner`s manual
10 11
www.CurrieTech.com
Currie Technologies
®
Currie Technologies
®
OM Direct Drive Scooters - 2012.indd
Modied 05/25/2012
1. Insert the stem into the
steerer tube. Be sure
to insert stem past the
“Minimum Insertion Mark”.
Section 4 - REPAIR & MAINTENANCE
IMPORTANT: Some adult assembly required.
HANDLEBAR ASSEMBLY AND ADJUSTMENT
Electro-Drive™ scooters are equipped with an folding stem hinge. Take care
not to pinch your hands or fingers in the hinge when you are folding and
locking the handlebar in place. Additionally be careful not to pinch or crimp
the brake and throttle cables in the hinge whenever you fold the stem hinge.
Photo B
2. Open the stem quick release
(QR) lever (Ref Photo A)
and rotate it forward out
of the upper plate (Ref
Photo B, step 1). Slide the
QR retention pin (silver)
sideways (Ref Photo B, step
2) to disengage it from the
upper plate.
Photo A
2
1
If the
quick release lever is either
too tight (cannot be flipped to
its fully locked position) or is
too loose (can be too easily
flipped to its locked position)
refer to the “QR Lever Adjust-
ment” on page 14.
WARNING
!
3. Open the stem hinge to
access the steerer bolt
(6mm Allen Bolt or 13mm
Hex Bolt).
4. Loosely tighten the steerer
bolt. The stem is held in
position with the expander
bolt and wedge.
5. Slide the QR retention pin
(silver) sideways (Ref Photo
A). Close the stem hinge
(Ref Photo B).
Photo A
Photo B