Owner`s manual

32 33
www.CurrieTech.com
Currie Technologies
®
Currie Technologies
®
OM Direct Drive Scooters - 2012.indd
Modied 05/25/2012
Never inate a tire beyond the maximum pressure
imprinted on the sidewall
• HOW OFTEN SHOULD I RECHARGE THE BATTERIES?
Recharge your batteries immediately after every ride. Your scooter will
perform best when the batteries are fully charged. To help prolong battery
life be sure they are fully charged before you store the scooter for any
extended period of time and that the batteries are charged at least every
90 days.
• HOW LONG SHOULD MY BATTERIES LAST?
With proper care, batteries can last up to 200 charges or approximately 6
months.
• HOW LONG SHOULD IT TAKE TO CHARGE A FULLY DISCHARGED
BATTERY?
Up to 6-10 hours (depending on battery size) using the Currie charger
supplied with the scooter.
Note: Charge time is based on new batteries charged with a standard
charger.
• WHERE CAN I PURCHASE ADDITIONAL OR REPLACEMENT PARTS, IF
NEEDED, SUCH AS BATTERIES, WHEELS OR A FASTER CHARGER?
Parts can be purchased directly from Currie Technologies
®
by calling
1-800-377-4532.
* Keep a copy of your purchase receipt on hand and available in case you
should need utilize the limited warranty. We recommend you attach a copy of
your receipt to this manual and store both in a safe and secure location.
Section 6 - PRE-RIDE CHECKLIST
It is recommended that you perform each of these checks before each and every ride.
TIRES
□ Check tires for any cuts or unusual wear.
□ Check tire pressure and inflate to the pressure recommended on the sidewall.
HANDLEBARS and FRAME
□ Inspect for bent, damaged or cracked welds and tubing caused by aggressive
riding.
□ Ensure the handlebars are properly aligned and secured tight enough so that you
cannot twist them out of alignment.
NUTS and BOLTS
□ Inspect and tighten all fasteners before each and every ride.
□ If unsure on how to inspect and tighten fasteners, seek advice from an authorized
and experienced mechanic.
BRAKES
□ Ensure brake control cable(s) are lubricated, correctly adjusted and display no
obvious wear.
□ Ensure brake control lever(s) are not binding and the clamps are tightly secured to
the handlebar.
□ Squeeze the brake lever(s) to make sure that it does not bottom out on the handle-
bar and the brake(s) holds the scooter from being pushed forward.
□ Squeeze the brake lever(s) to ensure the brake inhibitor(s) stop the motor.
□ Ensure brake shoe pads are not worn out and are correctly positioned.
ELECTRICAL SYSTEM
□ Be sure the batteries are fully charged by using the battery gauge (colored LED’s)
on the throttle.
□ Ensure your battery pack is properly installed in your scooter with the deck plate
attached and secured.
□ Ensure the accelerator are secure, in good condition and working properly.
RIDING GEAR
□ Always wear an approved helmet.
□ Always wear proper protective equipment such as; eye protection (goggles or face
shield), gloves, boots, long sleeved shirt or jacket and long pants.
□ Never operate this product barefoot or in sandals as this increases the risk of
injury.
□ Always obey all local traffic laws
OM eZip Direct Drive Scooters 2010 rev 1
WARNING
!