Owner`s manual
26 27
www.CurrieTech.com
Currie Technologies
®
Currie Technologies
®
OM Direct Drive Scooters - 2012.indd
Modied 05/25/2012
WHEEL INSTALLATION
FRONT WHEEL INSTALLATION:
500DD, 750DD, 1000DD AND SCOOT-E
DD SERIES SCOOTERS
If your scooter is equipped with a
V-Brake you will need to disengage it
prior to installing the front wheel.
Do so by squeezing both of the brake
arms together and unhooking the
brake noodle.
1. Place the front wheel into the
forks being sure the axle is fully
seated into the dropouts.
2. Install the safety washers into
the dropouts. (Ref Photo A)
3. Install the axle nuts. (Ref Photo
B)
4. Check to ensure the wheel is
centered in the fork. (Ref Photo
C)
5. Tighten the axle nuts. (Ref
Photo D)
6. Reattach the V-Brake if your
scooter was so equipped.
Proper braking
performance is critical for safe
riding. Currie Technologies® strongly
recommends that the brake(s) be
tested to ensure they are working
properly.
Do not ride the
scooter to check the brakes.
Photo A
Photo B
Photo C
Photo D
WARNING
!
WARNING
!
REAR WHEEL INSTALLATION
500DD, 750DD AND 1000DD SERIES SCOOTERS
The order of this installation is very important.
1. Align the RIGHT bearing cap holes with the threaded holes on the
frame. Loosely secure with only 1 bolt at this time.
2. Align the LEFT bearing cap holes with the threaded holes on the
frame. Loosely secure with only 1 bolt at this time.
3. Repeat steps 1 & 2 until all of the bearing cap mounting bolts are
loosely installed.
4. Align the torque arm mounting bracket with the threaded holes on the
frame. Loosely secure with all 3 bolts at this time.
5. Fully tighten both left and right bearing cap bolts and torque arm
mounting bolts at this time.
Proper braking performance is critical for safe riding. Currie Technologies®
strongly recommends that the brake(s) be tested to ensure they are working
properly.
Do not ride the scooter to check the brakes.
REAR WHEEL INSTALLATION
SCOOT-E DD SERIES SCOOTERS (REAR RIGHT WHEEL)
1. Install the machine key into the groove on the axle.
2. Line up the groove on the wheel with the machine key and install
wheel onto rear axle being sure to point the valve to the outside.
3. Secure with washer and nut.
SCOOT-E DD SERIES SCOOTERS (REAR LEFT WHEEL)
1. Install wheel onto axle being sure to point the valve to the outside.
WARNING
!
WARNING
!