Technical information
12 13
www.CurrieTech.com
OM Chain Drive Scooters - 2012.indd
Modied 05/25/2012
Currie Technologies
®
Currie Technologies
®
8. Align the handlebars to the
front wheel. The handlebars
must be perpendicular to the
front wheel.
9. Repeat steps 2 and 3
to once again access the
steerer bolt (6mm Allen Bolt
or 13mm Hex Bolt). Fully
tighten the steerer bolt.
The stem is held in position
with the expander bolt and
wedge.
10. Repeat steps 5 and 6
to once again secure the
folding stem. Be sure the
QR retention pin (silver) is
fully engaged with the upper
plate.
WARNING
!
If you are unable to lock the handlebar folding hinge
properly, or its Quick- Release lever, or properly secure
the two main handlebar parts to the scooter, DO NOT
RIDE THE SCOOTER. Contact Currie Technologies
®
Customer Service at 1-800-377-4532 for further
instructions. Failure to do so may result in serious injury
or death to the rider or severe damage to the scooter.
6. Rotate the stem QR lever
forward into of the upper
plate (Ref Photo A). Close
the stem QR lever (Ref
Photo B) being sure the QR
retention pin (silver) is fully
engaged with the upper
plate.
7. Install the handlebars onto
the stem, align and tighten.
Photo B
Photo A